Below you will find specifications as measured for these transmitter kits. Figures reflect typical specifications as sampled from random samples.

Spec Type

LED Series

LCD Series

Notes

Frequency Range (87.7 - 107.9) MHz (87.7 - 107.9) MHz 0.1 MHz increments (click)
Frequency Stability < 0.0005% < 0.0005% Of set frequency
Frequency Accuracy < 0.001% < 0.001% Of set frequency
RF output (standard) 10mW (+10dBm) into 50Ω 1-100mW into 50Ω  
RF output (high) 100mW(+20dBm) into 50Ω   Switchable 10/100 mW
RF output LCD   1-100mW into 50Ω Adjustable 1-100mW
RF muting during tuning period -20dBc < -40dBc RF reduced dB below carrier
VSWR Withstand 20:1 Withstand 20:1 No damage
Phase noise (dBc/Hz) VCO output VCO output Commercial VCO's specs
1 kHz offset -84dBc/Hz -92dBc/Hz in the range 87-108
10 kHz offset -90dBc/Hz -117dBc/Hz for comparison
20 kHz offset -94dBc/Hz -125dBc/Hz (click here for more)
100 kHz offset -104dBc/Hz -136dBc/Hz  
Residual FM 14Hz (300-3kHz) BW <1Hz (50-15kHz)BW LCD VCO vs HP RF gen
Incidental AM <0.2% <0.1% RF OUT- LCD vs FM30 noise
RF Harmonics out 10mW (-30dBc) 100mW(-50dBc) -60dBc or better  
Spurious Output -50dBc or better -60dBc or better  
SNR (Signal-Noise-Ratio) 60dB or better 75dB or better  
Audio Distortion (%THD) 0.3% @ 1kHz 0.1% @ 1kHz  
Stereo Separation 28-40dB @ 1kHz 30-45dB @ 1kHz Limited by stereo encoder chip BH1415, BH1414
Audio Response 20 Hz - 15 kHz 20 Hz - 15 kHz LCD filter profile
Max Input Level
(RCA line)
500 mV rms 500 mV rms (Click here for more info) make
Max Input Sensitivity 100mV p-p 100mV p-p to obtain 75kHz deviation
Power Requirement Clean Regulated 12V Clean Regulated 12V PSU must be regulated
  150mA for 10mW operation 250mA  
  250mA for 100mW operation    
Antenna Needs 50Ω - 75Ω impedance 50Ω - 75Ω impedance 1m wire antenna supplied
Transmit Range Range will depend on various factors like, location, interference, type of receiver etc. 10mW unit (200-400)ft
with good receiver
Reserving the right to change any specification without notice

SPECIFICATIONS